QX-5 Twenty : Digital Hub

Ayre QX-5 Digital Hub Firmware Revision History

Release Information:

Release date: September 6, 2017.
Category: Latest Official Release

General Firmware Version: G

For a list of previous revisions, click here.

Release Notes:

This firmware is designed only for the Ayre QX-5. Compared to the previous official release of firmware revision F, this version corrects a bug with sample rate timing changes and clock mode selection. It also updates the network naming for the unit.

Bug Corrections:

  • Created a sample rate timing change to avoid issues with DSD/PCM switching and drop-outs on some units.
  • Corrected a critical bug that caused the clock mode to behave incorrectly. This caused issues with MUSIC mode of all S/PDIF inputs to output lower quality sound than expected as well as prevented VIDEO mode from syncing correctly.

Improvements:

Updated the model name on the network list to help identify it on the network with new products.

Known Issues:

An issue was recently discovered that can cause short drop-outs in audio while playing DSD files over the network. When the DSD flag is brieftly lost, this will sound like brief pops or drops in output. The correction for this bug will be implemented in rev. H.


Release Information:

Release date: July 13, 2017.
Category: Latest Official Release

Network Firmware Version: 03.02.03
General Firmware Version: F

For a list of previous revisions, click here.

Release Notes:

This firmware is designed only for the Ayre QX-5. Compared to the previous official release of firmware revision E, this version corrects a potential issue with playing 384 kHz files and Qobuz capability.

Bug Corrections:

Corrected a timing error that could cause issues with some units causing a "popping" noise while playing 384 kHz files.

Improvements:

Added Qobuz capability via the network! User must have an active Qobuz subscription to access this service.

Note:

Ensure both the network firmware as well as the main firmware (installed via flash drive) have been installed.


Release Information:

Release date: March 1, 2017.
Category: Latest Official Release

Network Firmware Version: 03.00.03
General Firmware Version: E

For a list of previous revisions, click here.

Release Notes:

This firmware is designed only for the Ayre QX-5. Compared to the previous official release of firmware revision E, this version focuses on enhancing AyreLink interactions between products.

Bug Corrections:

Updated settings saving to improve reliability when updating firmware to future revisions. This addresses the known issue from revision D.

Improvements:

    • If the unit is in DAC mode and the volume is changed, it will generate a volume up (QVU) or volume down (QVD) over AyreLink to other devices.
    • If the QX-5 receives a QOF command over AyreLink, it will no longer go into standby. This is a correction to match the AyreLink specification and make the product act consistently with other products.



    Release Information:

    Release date: January 12, 2017.
    Category: Latest Official Release

    Network Firmware Version: 03.00.03
    General Firmware Version: D

    For a list of previous revisions, click here.

    Release Notes:

    This firmware is designed only for the Ayre QX-5. Compared to the previous official release of firmware B revision, this version focuses on correcting some playback bugs introduced in revision C.

    Bug Corrections:

    All bugs were addressed with the same update. Issues observed with firmware revision C include:

      • When using an input in video mode, no output is heard when sample rate is changed.

      • When changing sample rates, output can become distorted or stop entirely.

    Known Issues:

    Occassionally, some settings may be lost when updating the firmware. If any issues are encountered after upgrading, it is recommended to cycle the unit off and then back on after ~30 seconds and then performing a system reset on the unit to reset all inputs to their factory defaults. Please see the owners manual for instructions on how to perform a factory reset in the setup menu.



    Release Information:

    Release date: December 19, 2016.
    Category: Latest Official Release

    Network Firmware Version: 03.00.03
    General Firmware Version: C

    Release Notes:

    This firmware is designed only for the Ayre QX-5. Compared to the previous official release of firmware 02.08.09 and general firmware B, this version focuses on improving Roon operability, USB functionality, clock switching handling, AP/WPS mode functionality, and some minor aethetic changes.

    Please note that BOTH the network and general firmwares must be updated seperately in order to complete the update.

    Interface Updates:

      • "WAIT" added to the AP and WPS functions while they initialize as well as to the IP Address screens. This provides more feedback to the user while the system waits for responses from the CDMCM-210 module.

      • Custom names for each input after AES1 were defaulted to all blanks instead of "CUST". They now default correctly to "CUST".

    Major Updates:

      • Roon certification required several adjustments be made to the PIC firmware and the CDMCM-210 firmware. These changes improved/perfected synchronization between the QX-5 and Roon. Firstly, the QX-5 can now be brought in and out of stnabdy using a standby button in Roon. Secondly, if the QX-5 is in standby, when playback starts through Roon, the QX-5 will automatically exit standby and jump to the network input. Other small details were also addressed to meet Roon certification compliance.

      • Resolved flaw in the code where the the processor can enter a bad state and the unit will stop playing. This issue has now been resolved.

      • An issue with clock switching has been resolved. Previously, switching between sample rates could cause one of the oscillators to not power on. This issue has been resolved.

      • Small modifications to the code have been made to the AP and WPS functions to improve reliability.

      • The QX-5 can now play .dsf files that are recorded as DSD64 natively.

    Minor Updates:

      • Firmware bug could cause the Ethernet module and the QX-5 mute flags to become unsychronised. This issue has been resolved.

      • Start-up code has been adjusted to improve network function reliability.

      • Ethernet module will report installed firmware even when no network connection is present.




    Release Information:

    Release date: October 12, 2016.
    Category: Latest Official Release

    Network Firmware Version: 02.08.09
    General Firmware Version: B

    Release Notes:

    This firmware is designed only for the Ayre QX-5. Compared to the previous official release of firmware 02.07.13 and general firmware A, this version focuses on addressing a few bugs discovered at release.

    Please note that BOTH the network and general firmwares must be updated seperately in order to complete the update. If only one update is completed, the unit will still exhibit the same behavior as the previous firmware version.

      • Resolved a bug encountered when connecting to the network via AP mode. This bug caused the QX-5 to display
        "AP ..." and never display "CONNECTED", even after having found the network. The unit will now correctly display "CONNECTED" when it has successfuly connected to the network.

      • Resolved a bug that could occasionally cause the network playback to drop off while switching to inputs other than 10. This was encountered in some networks while actively sending the network module a file while simultaneously playing a different sample rate through a different input that was selected. This would cause the module to no longer respond to commands until the unit was powered off and back on.

      • Added AyreLink ID "D" when selecting DX-5 from the pre-programmed inputs naming list.

      • Modified the QX-5 to only accept volume up/down commands via AyreLink for product ID "Q" to avoid conflicts with other Ayre devices found in a typical system. Before it would accept all AyreLink volume commands regardless of product ID.

      • Added an option to reset the network connection via the Setup Menu (found under NET). This allows the user to force the network module to search again for a network connection via a connected Ethernet connection and can be used if a connection is not found when first setting the unit up. Before, the QX-5 may not see an Ethernet connection if the Ethernet cable is connected after the unit has already been plugged in and powered on and could only be reset by turning the power off and back on again. Using reset also forces the network module to forget all WiFi settings and device naming previously setup. This is useful if using the QX-5 wirelessly with a different network.




    Release Information:

    Release date: July 12, 2016. Category: Latest Official Release

    Network Firmware Version: 02.07.13
    General Firmware Version: A

    Release Notes:

    This firmware is designed only for the Ayre QX-5. This is the initial release firmware.



    Contact Ayre Support:

    Ayre Acoustics, Inc.
    2300-B Central Avenue
    Boulder, CO 80301 USA

    Phone: (303) 442-7300